Copy and Paste the entities

General Topics related to ActCAD Software
Sai Ram
Posts: 87
Joined: Mon Oct 17, 2016 6:54 am

Copy and Paste the entities

Postby Sai Ram » Mon Oct 17, 2016 2:10 pm

Copy and Paste does not work. I can not copy the drawing in another drawing ?

Sai Ram
Posts: 87
Joined: Mon Oct 17, 2016 6:54 am

Re: Copy and Paste the entities

Postby Sai Ram » Wed Oct 19, 2016 5:13 am

The reason could be that the drawing from which entities are being copied was closed. -- Make sure the file from which the entities were copied is still open. -- If it proves closed: open the file of the drawing of origin, select entities to be copied from the Edit menu and choose "Copy" or "Copy with Base Point." -- Open or move into the drawing of destination without closing the drawing of origin, Edit menu and choose Paste "or" Paste to Original Coordinate". NOTE: The right way to copy is always use the command "Copy" from the Edit menu


Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 6 guests